B1258:4B [DASH_ESU]
id990260116400
Details On DTCs
| System malfunction location |
Abnormal rear vent actuator temperature |
|
|---|---|---|
|
Detection condition
|
Determination conditions
|
• The dash-electrical supply unit detects an abnormally high temperature condition in the rear vent actuator.
|
|
Preconditions
|
• Not applicable
|
|
|
Malfunction determination period
|
• Not applicable
|
|
|
Fail-safe
|
• Rear vent actuator drive signal is stopped right when the malfunction is determined.
|
|
|
Vehicle status when DTCs are output
|
• Not applicable
|
|
|
Possible cause
|
• Malfunction in wiring harness (including connector/terminal) between rear vent actuator and dash-electrical supply unit
• Rear vent actuator malfunction
• Dash-electrical supply unit malfunction
|
|
System Wiring Diagram
bda2zd00000794
|
|
1
|
Dash-electrical supply unit
|
|
2
|
Rear vent actuator
|
Function Explanation (DTC Detection Outline)
• Not applicable
Repeatability Verification Procedure
• Not applicable
Function Inspection Using M-MDS
• Not applicable
Troubleshooting Diagnostic Procedure
| Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
PURPOSE: INSPECT WIRING HARNESS (INCLUDING CONNECTOR/TERMINAL) BETWEEN REAR VENT ACTUATOR AND DASH-ELECTRICAL SUPPLY UNIT FOR MALFUNCTION
• Inspect the applicable circuit. (See CIRCUIT INSPECTION.) (See CONNECTOR INSPECTION.)
• Is the circuit normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the malfunctioning location and perform the repair completion verification 1.
|
||
|
2
|
PURPOSE: VERIFY IF REAR VENT ACTUATOR TEMPERATURE WAS TEMPORARILY HIGH
• Start the engine/PHEV/EV system and move the vehicle to a cool place.
• Switch the ignition off/main power OFF and wait for 30 min or more.
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Perform the DTC inspection for the dash-electrical supply unit. (See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Replace the rear vent actuator and perform the repair completion verification 1.
|
|
No
|
Go to repair completion verification 2.
|
||
|
Repair completion verification 1
|
PURPOSE: VERIFY THAT VEHICLE IS REPAIRED
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Perform the DTC inspection for the dash-electrical supply unit. (See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction recurs, replace the dash-electrical supply unit, then go to the next step. (Refer to [DASH-ELECTRICAL SUPPLY UNIT REMOVAL/INSTALLATION] in workshop manual.)
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification 2
|
PURPOSE: VERIFY IF OTHER DTCs ARE DISPLAYED
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are any other DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|