DTC Lookup

B00D2 DTC

Communication error with instrument cluster (air bag/seat belt pre-tensioner system warning light status mis-matched)

Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector

Possible Causes

  • injury or damage the system due to a mis-operation. When performing an

SAS

B00D2:01 [SAS]

SM3341968

id9902k0101200

Details On DTCs

System malfunction location

Air bag/seat belt pre-tensioner system warning light malfunction
Detection condition
Determination conditions
Warning
• Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection only under the detection conditions may cause injury or damage the system due to a mis-operation. When performing an inspection, always follow the diagnostic procedure.
• Air bag/seat belt pre-tensioner system warning light malfunction is detected.
Preconditions
• Not applicable
Determination period
• Not applicable
Fail-safe
• Not applicable
Vehicle status when DTCs are output
• Not applicable
Possible cause
• Instrument cluster malfunction (air bag/seat belt pre-tensioner system warning light malfunction)
• SAS control module malfunction

System Wiring Diagram

• Not applicable

Function Explanation (DTC Detection Outline)

• Not applicable

Repeatability Verification Procedure

• Not applicable

Function Inspection Using M-MDS

• Not applicable

Troubleshooting Diagnostic Procedure

Step

Inspection

Results

Action
1
PURPOSE: INSPECT INSTRUMENT CLUSTER FOR MALFUNCTION DEPENDING ON REPEATABILITY
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Perform the DTC inspection for the SAS control module. (See DTC INSPECTION.)
• Is the same DTC displayed?
Yes
Refer to the CAN (controller area network) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, replace the instrument cluster and perform repair completion verification 1.
No
Perform repair completion verification 2.
Repair completion verification 1
PURPOSE: VERIFY IF VEHICLE IS REPAIRED
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Perform the DTC inspection for the SAS control module. (See DTC INSPECTION.)
• Is the same DTC displayed?
Yes
Refer to the CAN (controller area network) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1 again.
• If the malfunction is not resolved, replace the SAS control module, then go to the next step. (Refer to [SAS CONTROL MODULE REMOVAL/INSTALLATION] in workshop manual.)
No
Go to the next step.
Repair completion verification 2
PURPOSE: VERIFY IF OTHER DTCs ARE DISPLAYED
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are other DTCs displayed?
Yes
Repair or replace the malfunctioning location according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.