B0099:29 [SAS]
id9902k0804500
System malfunction location
• Roll rate sensor in SAS control module (internal circuit disabled)
Detection condition
-
Warning
-
• Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection only under the detection conditions may cause injury or damage the system due to a mis-operation. When performing an inspection, always follow the diagnostic procedure.
• Malfunction in the sensor in the SAS control module.
Fail-safe
• (See DTC TABLE [SAS].)
Vehicle status when DTCs are output
• Not applicable
Repeatability verification procedure
1. Clear the DTC recorded in the memory. (See CLEARING DTC.)
Inspection/Action Procedure
• Inspect and take action in order from Step 1 below.
• After repairing or replacing a part, perform the repeatability verification procedure and perform a DTC inspection.(See DTC INSPECTION.)
-
― If the same DTC is displayed again as a result of the DTC inspection, go to the next step.
1.Replace the SAS control module.
|
Purpose/reason (possible cause)
|
SAS control module malfunction (applicable part malfunction determined by this DTC)
|
|
Applicable workshop manual items
|
SAS CONTROL MODULE REMOVAL/INSTALLATION
|
System wiring diagram
• Not applicable
Function Explanation (DTC Detection Outline)
• Not applicable