DTC Lookup

B0095 DTC

• Short circuit to crash zone sensor (center) and other air bag sensor circuits

Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector
Component Connector

Possible Causes

  • injury or damage the system due to a mis-operation. When performing an

SAS

B0095:2B [SAS]

SM3591005

id9902k0804000

System malfunction location

• Short circuit to crash zone sensor (center) and other air bag sensor circuits

Detection condition

Warning
• Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection only under the detection conditions may cause injury or damage the system due to a mis-operation. When performing an inspection, always follow the diagnostic procedure.
• Malfunction in wiring harness between crash zone sensor (center) and SAS control module.
• Crash zone sensor (center) malfunction

Fail-safe

• (See DTC TABLE [SAS].)

Vehicle status when DTCs are output

• Not applicable

Repeatability verification procedure

1. Clear the DTC recorded in the memory. (See CLEARING DTC.)

Inspection/Action Procedure

• Inspect and take action in order from Step 1 below.
• After repairing or replacing a part, perform the repeatability verification procedure and perform a DTC inspection.(See DTC INSPECTION.)
― If the same DTC is displayed again as a result of the DTC inspection, go to the next step.

1.Verify the installation condition of the crash zone sensor (center).

If the crash zone sensor (center) is not correctly installed, install it correctly.

Purpose/reason (possible cause)
Poor crash zone sensor (center) installation
Applicable workshop manual items
CRASH ZONE SENSOR REMOVAL/INSTALLATION

2.Inspect the wiring harness (including connector/terminal) between the crash zone sensor (center) and SAS control module.

Purpose/reason (possible cause)
Malfunction in wiring harness (including connector/terminal) between crash zone sensor (center) and SAS control module
Applicable workshop manual items

3.Inspect the crash zone sensor (center).

Purpose/reason (possible cause)
Crash zone sensor (center) malfunction
Applicable workshop manual items
CRASH ZONE SENSOR INSPECTION

4.Replace the SAS control module.

Purpose/reason (possible cause)
SAS control module malfunction (applicable part malfunction determined by this DTC)
Applicable workshop manual items
SAS CONTROL MODULE REMOVAL/INSTALLATION

System wiring diagram

image
bda1jd00000916
1
SAS control module
2
crash zone sensor (center))

Function Explanation (DTC Detection Outline)

• Not applicable